Structural and electrochemical studies of annealed LiNiVO4 thin films

We prepared stoichiometric lithium nickel vanadate amorphous thin films by using r.f. magnetron sputtering under controlled oxygen partial pressure. The amorphous films were heated at various temperatures, 300–600 °C, for 8 h. The as‐deposited and annealed thin films were characterized by Rutherford backscattering spectroscopy, nuclear reaction analysis, Auger electron spectroscopy, X‐ray diffraction, scanning electron microscopy and atomic force microscopy. The electrochemical behavior of the various films was studied by the galvanostatic method. The cells were tested in a liquid electrolyte at room temperature, with lithium metal used as the counter and reference electrode. The best electrochemical storage value was obtained with the thin film annealed at 300 °C, which showed superior capacity and small capacity loss during cycling. Copyright © 2007 John Wiley & Sons, Ltd.     

煅烧温度对Li4Ti5O12的电化学性能的影响

用溶胶-凝胶法制备了尖晶石型锂钛复合氧化物L i4Ti5O12,并研究了煅烧温度对其电化学性能的影响。结果表明,在800℃煅烧12 h得L i4Ti5O12,晶型良好,粒度较均匀。并且表现出良好的电化学性能,循环10次后比容量仍保持在160 mAh.g-1左右。     

Deposition of Oral Bacteria and Polystyrene Particles to Quartz and Dental Enamel in a Parallel Plate and Stagnation Point Flow Chamber

The aim of this paper is to determine to what extent (i) deposition of oral bacteria and polystyrene particles, (ii) onto quartz and dental enamel with and without a salivary conditioning film, (iii) in a parallel plate (PP) and stagnation point (SP) flow chamber and at common Peclet numbers are comparable. All three bacterial strains showed different adhesion behaviors, and even Streptococcus mitis BMS, possessing a similar cell surface hydrophobicity as polystyrene particles, did not mimic polystyrene particles in its adhesion behavior, possibly as a result of the more negative ζ potentials of the polystyrene particles. The stationary endpoint adhesion of all strains, including polystyrene particles, was lower in the presence of a salivary conditioning film, while also desorption probabilities under flow were higher in the presence of a conditioning film than in its absence. Deposition onto quartz and enamel surfaces was different, but without a consistent trend valid for all strains and polystyrene particles. It is concluded that differences in experimental results exist, and the process of bacterial deposition to enamel surfaces cannot be modeled by using polystyrene particles and quartz collector surfaces.     

单斜层状LiMnO2的球磨-离子交换法合成及其电化学性能研究

通过球磨促进固相反应法合成出了具有单斜层状结构的前驱物NaMnO₂，随后通过离子交换得到了单斜层状LiMnO₂。XRD测试结果显示产物为单相。扫描电镜(SEM)和透射电镜(TEM)观测结果显示LiMnO₂的粒子尺寸为300～500 nm，HRTEM分析显示干扰条纹的间距为0.485 nm，基本对应于m-LiMnO₂的(001)晶面间距。红外吸收光谱(IR)和X射线光电子能谱(XPS)被用来测量m-LiMnO₂中Mn-O键的伸缩和弯曲振动吸收和Mn元素的价态。合成的m-LiMnO₂在电化学充放电循环初期表现了较好的电化学性能，但其循环寿命仍需要进一步改善。     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．     

七-O-乙酰基-β-乳糖异硫氰酸酯的合成、表征及电化学研究

本文合成了并培养出了七-O-乙酰基—β—乳糖异硫氰酸酯的单晶，用X射线衍射分析了其晶体结构。结果表明，晶体为正交晶系，P2₁2₁2₁空间群，a＝1．23282(7)，b＝1．80012(10)，c＝1.85230(10) nm，α＝β＝γ＝90°，V＝4．1107(4) nm³，Z＝4。电化学实验观测到单链DNA和双链DNA对该化合物的峰电流均有明显降低作用，表明化合物与DNA发生了静电作用。     

Solvothermal Synthesis, Crystal Structure and Electrochemical Property of Complex [Co(p-MBA)2(2,2''-bipy)(H2O)]·(H2O)

One novel complex [Co(p-MBA)2(2,2'-bipy)(H2O)]·(H2O) has been synthesized by the reaction of p-methylbenzoic acid with 2,2'-bipyridine in the solvent mixture of water and methanol. It crystallizes in triclinic, space group P-1 with a=0.70479(14), b=1.1211(2), c=1.6718(3) nm, α=103.806(3), β=90.795(3), γ=104.207(3)°, V=1.2399(4) nm3, Mr=512.41, Dc=1.373 g/cm3, Z=2, F(000)=532, μ=0.733 mm-1, R=0.0432 and wR=0.0957. The crystal structural analysis shows that the cobalt atom is coordinated with three oxygen atoms from two p-methylbenzoic acids and one water molecule and two nitrogen atoms from one 2,2'-bipyridine,forming a distorted square-pyramidal coordination geometry. The cyclic voltammetry behavior of the complex is also reported.     

微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

酞菁锰-表面活性剂薄膜电极的电化学表征及其对三氯乙酸的电化学催化作用的研究

将酞菁锰（ＭｎＰｃ）掺入阳离子表面活性剂双十二烷基二甲基溴化铵（ＤＤＡＢ）的氯仿溶液，并涂布于热解石墨电极表面，待氯仿挥发后即制得ＭｎＰｃ－ＤＤＡＢ薄膜电极。循环伏安实验表明，在ＫＢｒ溶液中，该薄膜电极有两对还原氧化峰，第一对峰的Ｅｐｃ１＝－０．２７Ｖ，Ｅｐａ１＝０．０１Ｖ；第二对峰的Ｅｐｃ２＝－０．７６Ｖ，Ｅｐａ２＝－０．６２Ｖ（ｖｓ．ＳＣＥ）。本文着重探讨了第二对峰的电化学行为，估计了该体系的电荷传递扩散系数Ｄｃｔ和表观非均相电极反应速率常数Ｋ０′等电化学参数，并可将该薄膜电极用于催化三氯乙酸的电化学还原。     

Carbon nanotube assisted synthesis of CeO2 nanotubes

CeO₂ nanotubes have been synthesized facilely using carbon nanotubes (CNTs) as templates by a liquid phase deposition method. The properties of the CeO₂ nanotubes were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), X-ray photoelectron spectrum (XPS) as well as thermogravimetry and differential thermal analysis (TG-DTA). The obtained CeO₂ nanotubes with a polycrystalline face-centered cubic phase have a uniform diameter ranging from 40 to 50 nm. The CeO₂ nanotubes are composed of many tiny interconnected nanocrystallites of about 10 nm in size. The pretreatment of CNTs and calcination temperature were confirmed to be the crucial factors determining the formation of CeO₂ nanotubes. A possible formation mechanism has been suggested to explain the formation of CeO₂ nanotubes.